I'm a bit confused with the commissioning bit. I don't remember doing anything like that when I set it up before. Is this something that is done if its wired? Mine is all wireless.
Ok I found a really guide guide online so I have now managed to set the areas up.
Is there anyway of the keypad beeping when the front door is opened with the alarm unset?
Hi guys,
I'm back again and need help again please.
So my PIR sensor in my kitchen kept going dead. Changed the battery 2-3 times and today I got a replacement under warranty. Anyway I had to relearn the sensor and some how I managed to delete all the other sensors. I have now relearnt them...
Evening guys,
I'm back again!! So I finally got myself some time today to put up the bell box outside the house. The instructions said I could put the bell on holdoff mode while I'm fitting it as with the cover off the tamper will go off. Instructions said to press the "Omit" key when in Bell...
Ok i now have another issue. If I arm the alarm to full and walk through the front door and i put in my code it says "Code not allowed, use tag." Once I put the code in for the third time it'll disarm. I've only got one user code set up. I did have 4 in total but deleted them as I thought that...
Sorry not very good with alarm technical term. So when I have the whole house set and I open the front door to come in I get 10 seconds to disarm which is fine. When I have it set when we're in bed (part set) the front door still allows 10 seconds before the alarm is triggered and siren sounds...
Sorry guys need a bit more help.
So I have areas set up BUT I need the alarm to go off when the front door is opened on 2 areas. At the moment I'm getting a 10 second delay on all areas. I've had a look through the settings and can't find a way to change them.
Any ideas?
Thank you
This was exactly the problem. I had them all set to hybrid. Reset the whole system and relearned all the sensors and siren. Everything is working as it should :D
Now just to work out how to program different areas.
Thank you
It doesn't show a time. Just a little spinning bar. I left it on for a good minute or 2 and still didn't get a count down timer. I just get a solid beep from the keypad.
As for the siren I've tried so many things. It's 100% registered according to the LEDs and the keypad shows sounder is...
Hi guys,
Just want to start off saying it's the first time I'm using this forum and hopefully I'll get the help needed to sort out my alarm.
So I've bought a Texecom 48 (metal box, I believe there's 2 different types.) and having trouble getting it to arm. So what I have is:
Premier Elite 48...