Recent content by sandysltd

Thanks zipper, yes I did check the front, and though I cant remember the readings, they did drop when put into hot water. Not so sure how to proceed still, don't want to risk £110 to find that its something else, but still don't want to pay such a high callout to Miele!! BTW where can the parts...

The resistance is about 150 at room temp...this does drop to around 30 when the tip has been in a cup of hot water for around 10 secs. There is continuity in the cables, and I have unplugged everything from the pcb and back in again, but still no heat!!

ok, will try that again later, I take it you are talking about the rear NTC?

ok, it is...dryer light flashes twice, then cool air flashes once. This then just seems to repeat itself

It was the rear that was changed, I'll look for the thread now

Sorry, had a w/e away....thanks for the reply. Dryer is no different on a timed / warm air cycle There is continuity back to the board through the cables Resistance readings with my meter set on 200k is 13.3 for the front ntc, but 114.2 on the rear ntc (sorry not so good with meters, may be...

Hi, I have a Miele T294c which isn't heating. I have checked and bypassed !! the thermostat..no difference. I ordered and fitted a new NTC sensor..no difference. I have resistance on my front NTC sensor, and continuity on the heat elements!....help please :?