Recent content by Sargro

So I did some more digging, and it seems that the stranded wire and low voltage requirement is only for US, as they do not use the Heatlink. The Nest manual that I linked to was not local, it's for US, so my bad, sorry for that. And I will be purchasing UK version in any case, so I do think it...

The snip that you give is referencing to the Terminal Block M2, where some proprietary Baxi remote control could be connected, while the thermostat should be connected to the block M1, and that is rated 230v. But if it doesn't really matter, then I guess all good. And I did see some similar...

thank you Stem, this solves a couple of headaches. I have a couple of other "stupid" questions. Now, would running extra wires form L and N boiler terminals (adding wires to what is already there) to the Heatlink, would make sense? It would be safer to do as you suggested and just run new mains...

Hello, I am trying to figure out how to connect the Nest and HeatLink to my condensing boiler - Baxi Duo Tec Compact+ 20 GA. It is a new set up, so no previous thermostat connection, and I do not have the Nest at hand - trying to figure out what I need and what is possible, before buying...