Recent content by Sebastian Demian

The circulation pump had harden detergent remains in it and the bearings must be replaced. Does someone know if 35 ohms are ok for a circulation pump? (the motor is 220-230Vac, 50Hz, 0.50A, 60W) with this values the resistance should be higher, I read that value between 20–40 ohms it's good but...

I'm back after watching for some hours videos on YouTube, the problem can be the bushings of the circulation pump, I will open it, last time I checked only the motor wiring and the impeller from outside, I didn't open it, the plastic cap was stuck, very little it moved by rotating, I will try it...

Hello, It was the thermostat, it didn't work properly and so the whole dishwasher was overheated, the glue from the duct tape what was wrapped over the wires was white and sticky, also in the circulation pump motor had I wire burned that was connected to the thermal protection fuse...

Hello Everyone, I'm new with all of this, my Candy CDI 1010 dishwasher was not working for some years and I started this week to check on it and find out that my heating element was not working, and the safety pressure switch also was burned, I had replaced them, and started the machine...