Recent content by sethno1ram

thanks everyone for the repies, i have sealed (for now) with silicon sealent the waste pipe round the edge to see if that stops the smells coming through. fingers crossed. :)

nope not gone one of them. the old toilet when we moved in didn't have one either. thanks 4pic :D

and whats a stub stack? :?

water level is good and covers the porcelain. whats an aav?

the trapseems a little low compared to the upstairs but it flushes fine. no mould growth tho. :)

the trap seems alittle low but it flushes fine. no mould growth cheers sethno1ram

howdy, i have a smelly downstairs toilet which is unbearable. the drains have been cleared and checked. the toilet is always clean and flushed at least once a day and yet the smell keeps emmitting from the wc. what is going on and how can i sort this out. man thanks ian

sorry if this is in the wrong forum/post etc but i really need some advice on a smelly downstairs toilet. i've had the drains cleared, the toilet is always clean and flushed at least once a day yet at times the smell that it gives of is horrendous. any advice or knowledge on this is gratefully...

hello, i ahve bought the v groove clip together laminate and am about to do under the door. i ahve removed the jambs but i cannot get the boards to clip and slide under. i have read that i should remove the groove and glue. Is this the best or only alternative? thank you in advance for any...

cheers kevnurse, re-thought my ideas and will leave the skirting alone and use beading. Thanks for your input. :)

thanks flooringman :)

Ok cheers guys, So i'll be removing the skirting. Should i remove all the skirting then? what is the be way to do this without damaging it, and getting out the nails and then putting it back on. Thanks again

i was going to use a jamb cutter, multi-tool etc, rater than remove the skirting board because i just know it'll either snap or the plaster will break away. Wasn't keen on using beading partly because of the prices and the fact that i'm pretty sh*t at intricate cuts. Don't know what to do, so...

Hi folks, Have read that i'll need to remove at least on of the skirting boards to fit my laminate flooring. Why? Why can't I just cut away at the bottom so i can slide the laminate under it? Advice gratefully received many thanks

Hi everyone, I am searching for this tool, bosch gfs 350 e Does anyone know where I can buy one? Thanks in advance