Recent content by silverbackaddick

not that im tight but i would much rather have a go at flushing it through rather than splash out for a newbie (£300ish)

cheers tony didnt really want to start messing with the HE i think i will just try and give it a flush through the pump what chemicals can you suggest or what do you use?

cheers tony only a squirt comes out of the valve nothing major is it easy to clean the heat exchanger mate? and will i need new door seal if i take it out?

aslo sometimes get a bit of steam coming out of bottom of door seal jhust before it cuts out does this mean the seals shot and this is where the air is getting into system?

could there be a problem with the expansion vessel if its shot would this be putting air into the system?? when i pressed the valve (like a car tyre valve) twice water came out

circuit board working cannot get ch working without having hot water on and thermovalve manually open, boiler kicks in then shuts off after banging about sometimes so bad sounds like theres a golf ball inside the boiler, because i can get hot water does this mean my heat exchanger is ok?? also...

No TW its not a combi was getting hot water and central heating after getting air out of the system but now seem to have a pcb problem fault 13 as it wont fire up fan starts but thats about it..

Hi guys happy new year well have had it running heating hot water but as soon as ch is involved it shuts down now cant even get it to fire up so nothing works

prv wasnt continuasly running, got some black scale out of block got it running but son as ch demand was given system got air in it again back to square 1

There is piping hot water entering the top of the block and freezing cold in the exit pipe. Also the red pullout valve is dispersing freezing cold water from the outside pipe. Thanks.

Hi all, would be grateful for a bit of help, although i'm sure the answers on here somewhere, i have a glow worm 30 xsi linked up with a megaflow tank beneath with drayton digistat wireless system. the HW has been working fine but the CH has been off through the summer because 3 rads were...