Recent content by simzep

Thanks for the advice. Installed it today, all set up, nice and straightforward.. now to set the schedule.

Thanks for the advice, hopefully installing it tomorrow. We currently don't have a room thermostat, which is the main reason for getting hive installed.. So should be fairly straightforward..

Hi, I'm about to replace my honeywell st9400c central heating/hot water controller with a hive system. I know that the hive can be attached straight to certain backplates of certain controllers. Would this be the case with mine? I have a conventional glow worm boiler.

Just fitted the new motor, works perfectly, thanks again Pete..

Thanks for your advice Pete. i have ardered a new synchron motor.I'll let you know how I get on when it arrives,Cheers Simon..

Hi, I have a glow-worm fuelsaver F boiler. This morning I discovered that the boiler is not firing up when the timer kicks in , and therefore getting no hot water. I have two independent motorised valves.There is resistance on both valves when overriding them. I have found that if I turn the...

Always learning,,,cheers...

Thanks very much to all for their help.I'm feeling a lot more confident about tackling the job now. :D

It Is a gravity fed system..The system does have two motorised valves one c/h and 1 h/w..I assume this would mean that each can operate independently?

Hi I'm looking to replace my old Honeywell st7100 programmer with a new st9400c.The connections on the st7100 are to 8(HW on) 5(CH on).A link between com 6 and com 4. A link between Live and com 3.And the usual live and neutral connections.Would I be right in thinking that I just need to connect...