Recent content by SLB

Hi Guys, I really need help with this. My bread machine was not heating up so i decided to check up the element, fuse, thermistor with a multimeter checking the Ohms and did not identify the fault but I guess i found a faulty diode which needs further inverstigation as well as the relay there a...

It is indeed divided there is 3 pipes linked to this gate valve one going to the loft the other 2 going down 1 is plastic 15 mmm the other 22mm copper

what for??? I do not intend to replace with lever just replace gate valve furthermore I think you can use a bung to stop cold water tank no?

hwct hot water cylinder tank

I replaced the gate valve sitting on the top of the HWCT. To do that I shut the cold feed outlet from the CWT however when I close The gate valve sitting on top of the HWCT the hot water is still running in my hot taps upstairs and downstairs?? The purpose of changing it was to be able to...

very good post to make sure that the water coming out of the cold water tank is shut properly in the loft I want to run the cold tap in the bath . When I do this procedure and no more water is coming out shall I close the tap in the bath before I reopened the cold tank outlet feed or leave the...

sounds more likely it is the cause what sort of insulation material is required and can a builder do it?

OK thanks to all the replies

do you think that is the reason any other clues? I had it checked up there about 2 years ago and he did a bit of flaunching somewhere up there

can a builder do it or do I have to call a specialist? could be a metal plate inside the cowl connecting with the flue loose?

what can i do to prevent it? It just started doing it!!!

I have a back boiler BAXI BERMUDA 50/4 during the winds I cannot sleep making a rattling metal noise coming from the chimney stack I guess it is coming from either the liner it might be getting loose where it connects with the flue and cowl any advice? PS I went to the loft and can confirm...

everyone I know busy until next friday will have to wait till then.

Hi All, My back boiler is starting playing up. It takes about 20 mins for it to ignite "start up" and makes like a small explusion seems like a lot of gas comes in one go? I decided to leave it on continiously and lowering down the room thermostat over night. Is it a good idea? the last...

CHECKED THE BATTERIES WITH MULIMETER ONE WAS VERY LOW REPLACED BOTH AND STAT BACK TO WORK. THANKS FOR HELP.