Like this?
http://www.tradingdepot.co.uk/DEF/product/!!ENF102/15X10!!/D016004/Plumbing%20Supplies%20&%20Heating%20Supplies/Copper%20End%20Feed%20Fittings/Copper%20End%20Feed%20Fittings%20-%20Fitting%20Reducers/End%20Feed%20Fitting%20Reducer%2015mm%20x%2010mm
We've currently got 10mm piping and a new Radiator is 15mm. The new Radiator is also not quite as wide and though I understand there will need to be some pipework, what are my options for fitting the 10mm to 15mm?
Joes was a good alternative but not what I wanted to do. My initial question related to a Nitromors method, of which is no good because they have changed the product so i'm seeking a product which is as good, if any. The paint isn't that good, it's flakey and poor in general so I was wanting to...
I've a whole kitchen/utility to do and the Nitromors was doing just fine, hence wanting an alternative. Using is a sander is a no go, it doesn't get in the tight areas like the liquid did. Think I'll try the heatgun and see how it goes, otherwise it's hunt for the old clear nitro.
Thanks but I don't really want to go down the sanding route. The old paint is pretty rubbish hence stripping right back. Are there no alternatives out there that compare to the original Nitromors?
Hi all,
Thought I had this all covered when I used my Nitromors on Skirtingboard and Architrave with just the results I was after. I want it back to pretty much bare wood so I can re-paint to a nice even texture.
Purchased some new Nitromors, it won't touch it which I understand is down to...