Recent content by steve28

Thanks sparkymarka - systems been fine since you sent me a transformer i have taken it apart and cleaned it even changed the code to previously unused pads, but its started to play up again. ill give it one more try and if that doesnt fix it i,ll replace with the newer model if its a straight...

Hi guys i have a worn keypad. There are two types of 9427. Are they interchangeable? or another option ? if anyone has the blue one in old stock id be happy to do a deal.. thanks in advance.

oh - so I must be misunderstanding how the system works then. I now know if `i arm the system and walk into a PIR line the siren goes off. It does not go off if I use the EE door despite how long i wait before disarming. Normal practice is to ARM and leave within 30 seconds or so. On...

because it sounds OK when I do a walk test.

Handymanjo - The strobe does work - but I noticed the two leds light in tandem, whereas previously they used to blink one then the other. I cant do any testing today as I have to go to office, but can look again tmw. Is there a suggestion as to an upgrade to the panel and keyboard keeping...

sparkymarka - I was not aware - however, I have walked in the EE door, and waited for a couple of minutes whilst the keypad beeped, and whilst the internal bell set off the external siren didnt. Ill do some more tests tmw as it seems to sound under some circumstances. Handymanjo - I'll look...

Handymanjo I just tried that, and hey presto the siren sounded - however I did it a second time and it did not sound outside, even when i triggered all zones one at a time. The panel lit up the zones as they were triggered so I know the PIRs are detecting movement. Same for a third and 4th...

Sparkymarka, thanks, Yes I am aware there is a 30 sec lag between entry and alarm to allow getting to the panel and disarming. What I'm saying is that I open the door and wait, because I want to check the siren will go off. But it doesnt sound at all. Just the inside bell, and i left it for...

Hi guys Well building work completed. System passes walk test, for all PIRS and also bell and siren. When armed though if I access EE door to set off , the internal bell sounds but not the external siren. Anyone have an idea why it should do that ? And any suggestions on panel replacement...

Hi guys, anyone know how to remove the black tape that comes with the skylight glass frames? i want to remove it for a clean perimeter, and get the glue off. image attached. any advice from glaziers would be appreciated.

Tnx. It was installed but years ago. Im sure i used the code once to swop out the PIRs. ill tape over it for now and likely replace the whole system in the new year. cheers

Hi, 0 enter 7890. Nothing happens. I expected all leds to flash but nothing.

Hi its a 9427 remote keypad. oo

Hi, can someone advise me please? I am having building work done, and need to disable or remove a PIR for a period. I thought I could enter eng mode and remove the pir to a different location but the code doesnt seem to work (no lights flash). I tried to remove the cover but the tamper switch...

OK, Thanks Denso13 and JohnD. Can either of you confirm that the lever screw comes out normally i.e. anti CW? or CW? The one I have seems to be seized and I dont want to force it unless i,m certain which way it will undo. I mailed Bristan as suggested, but dont expect a response till...