Recent content by SteveDub

Amazing, thank you so much that's extremely helpful! Oh and if I go the permanent live route (moving brown link) would I no longer need to link the L & COM in the receiver?

Hi mate, I've posted something similar and mines an old Ideal Classic too. Have a look at my thread, it may help too! Good luck. https://www.diynot.com/diy/threads/help-installing-and-moving-wireless-thermostat.600501/ Steve

Ahh, thank you so much that makes sense! My original idea was to wire to where the existing stat was but everything I read or watched seemed to say connect to the wiring centre! Yes it is a Y-Plan setup with 3 way valve and motorised actuator. I still may do this as I need to replace the...

Struggling here, if anyone can assist please?! (N.B. I'm aware of how messy it is and the broken center, will tidy afterwards!) I'm really struggling to get the permanent live to the receiver. So my multimeter has decided it wanted to fall apart!.. but before it did I checked and found a 240v...

Thank you! Yes very fair and correct point. Unfortunately the house design/build is not great and it is quite a substantial temperature drop downstairs. Although I understand completely the logic behind this, every way we have tried to balance the heat only ends up being an overwhelmingly and...

Hi, thank you! Sorry I just realised the loop/link wire on the programmer I was reffering to is actually BROWN! Which is linking from the main live terminal to the CH. It's hard to see in photo but on the wiring centre there are a squashed bunch of incoming cables, x3 lots plus the random...

Hi all, Looking for some help please. I'm fairly capable but started confusing myself a little! System boiler in kitchen with wall mounted programmable controller for HW & CH, water tank upstairs in cupboard. I have a Salus 510RF wireless thermostat, which I am looking to mount on middle floor...