Recent content by stevens1975

Thanks for everyone's help - I've swapped the CH and water wires over and everything is working as it should be.

Morning Right so this morning I've put the old programmer back on with the wires in the original configuration (see attached) but for ease as follows: Turquoise to N(choc block) linked to N Light blue in N Brown in L with a brown link to 5 Nothing in 1 Grey in 2 black and brown with red...

Hi Thanks alot for your reply. Attached is the photo as requested. someone told me to take the wire from no 5 as the hive doesn't have '5' and add it to the 'live' was this correct. If it helps I can explain which wires I taken out and put where. We didn't have a thermostat. Regards

Hi guys. I have a Potterton EP3000 remote controller and a Worcester Greenstar Camray Utility 25/32 I've upgraded to Hive but I've got a problem. I can fire the hotwater up and the boiler kicks in, however, when I try to fire up the CH, the hive registers that the central heating is on but...

Any ideas/help would be great. Thank you

And this is the wiring to the new Hive

This is the wiring to the old controller - Potterton

not sure if this will help?

Hi Guys Could do with some help please. This post has been very helpful to me but I seem to have encountered the same problem at the last hurdle as laneyweb I can fire the hot water and the boiler kicks in. However, when I try to turn on the CH by increasing the temp, the Hive boiler...