If it helps, this is the wiring diagram on the back of the existing receiver, which would suggest that there isn't currently any wire connected for HW & CH off:
Just about to have another go at it, and now confused by why there would be a live & what appears to be a neutral going into the same block on the wall controller backplate?! There's a red and blue wire both going into the existing backplate at position 'L'.
There is a yellow wire that's...
Thanks for the reply - I think it's point 2 I'm struggling with - the thermostat is in the hall and the boiler controls are in the kitchen, so no way of tracing a wire as all cables are buried in the wall, there is a yellow wire in the thermostat. but no yellow wires in the boiler controls. I've...
Hi
I've bought a Hive receiver & theromostat with dual HW & CH controls to replace the existing Drayton HW & CH timer control and wired thermostat. I tried to set it all up last weekend and everything was going well until I tried to replace the thermostat.
I set up the hive hub, changed the...
Hi
I've got a similar setup to the above and have also bought the Hive with dual HW & CH controls to replace the existing Drayton control and wired thermostat. I tried to set it all up last weekend and everything was going well until I tried to replace the thermostat.
I set up the hive hub...
Hi
Minor emergency - I've attempted to fit a new light in our en-suite bathroom, but stupidly didn't make a proper note of the wiring config before detaching the old light (trying to do it in a rush on a Saturday evening as the wife the wanted me to do some painting as well!).
This is the...