Recent content by Stewd

Thanks, Have just PM'd you the link.

The warning about the bell box power was when I first connected the bell box but didn’t have the 12v jumper on. Bell box is Texecom odyssey X3 (with backlight) Setup should be as followed: Full alarm = all zones Am full arming the system, did the part arm you can see on the log as a...

Turn't out to be the cable, new cabled arrived today and it linked up straight away. I will PM you the Log file & Panel printout

Went to download a copy of profile from Wintex & Log, but getting a unable to connect check settings. Will try to get hold of another USB cable and and see if that corrects the issue.

I will download a copy tomorrow and send it over. Thanks.

Zone 001-006: Areas: A.

That doesn’t make sense, here is the second test I did later in the day. Entry start 001 - 17:39.30 “Walk into zones 002, 003, 004” “Internal sirens went off” “Alarm area A, shown on keypad” Tag 003 - 17:39.57 Area disarmed - 17:39.57 Zone 002 Alarm- 17:39.57 Zone 002 Restore - 17:39.58...

Event log is as followed: AREA Armed - 14:04:38 Entry started 001 - 14:04.01 “Waved my hand over the zone 2 sensor to set the alarm off then left it for a minute to see if it was a delay issue” Tag 003 Stewart - 14:05.07 AREA Disarmed - 14:05.07 Zone 002 Alarm - 14:05.07 Zone 002 Restore -...

Hi, have searched the forum, but can’t find the answer, I have a newly installed Texecom premier elite 24, but the bell box isn’t sounding. If I set the alarm off by activating a zone when the alarm is set the internal sounder goes off and it reports on the keypad as “Alarm area A”. The...