Recent content by Stonking

Thanks all for the great help. I am leaving the broken bit in there for the moment until a get a new one (hopefully next weekend). Rather that than drive around with a hole in the hub. So next weekend the sucker comes out. Regards to all.

Good idea. Now that the top has come off I can get some PlusGas right inside and just keep topping it up. My other plan is to put lots of plus gas in there, screw a screw into it so that I have something decent to pull on and try and lever it out or maybe use some pulling device. Keep the...

It looks like cast steel. Its a 2004 Honda Accord.

Crap, the PlusGas dId not work. Now I will have to drill it all out. Is there not a danger that I will damage what is inside? Do I need to strip the hub down to do this? Reagrds to all.

Thanks as I do not have any releasong fluid now, any advice on a good one is appreciated. Regards Stephen

I really hope I do not have to drill it out because there really is not much room to get a drill in there. Stephen

Thanks all, sounds like a job for next weekend then after I have been to the shops for some releasing agent. I have already pulled with long nose pillers and pipe grips so I will just have to hope that releasing fluid does the trick. Stephen

Hi, I have removed the rear offside wheel, taken the 10mm bolt out that holds the sensor and pulled but the sensor does not slide out? What am I doing wrong? Thanks for your help. Stephen