Recent content by Stupida

So the cam was in the top with the original line up so I swapped them and flipped the door seems to work

One last thing… On the return panel I have to swap the hinges around to make it right handed. So do I have to flip the moving profile bar too? Does the hinge cam lift from the bottom or the top? Cheers

I got the plastic seal flush to the profile it came with a plastic tool. Made a pinging noise in the profile as I dragged it along, think that was normal? Appreciate your advise many thanks

I am installing a walk in enclosure for a low level shower tray and the advise in general is to silicon on the outside to allow water back in. However the profile I installed comes with a strip of wedge shaped translucent material that is wedged into the profile on the inside against the glass...

Anyone recommend an alternative to Marmox MSP360 Adhesive Sealant Something I could pickup from Screwfix?

What adhesive are you using for Marmox boards?

Did you get an answer as I am about to do the same thing

Has anyone installed an Abacus Concept1 raised shower former? Been looking at it and I can’t see why I couldn’t just use a slab of Cellotex to do the same job as the Abacus base? It doesn’t have a cement skin like the former or the boards it just looks like solid blue foam. Would be...

Thank you for the advice Noseall. The back end of the garage is going to be a shower room

I dug a channel in my 55 year old garage floor for 110 soil pipe and noticed the hardcore underneath is just old house bricks (whole and half) as well as general building rubbish. It also seems that its sunk down as I can reach under the slab a little next to the cut. Is there anything that...

Yes Cellotex or kingspan (120mm) and self levelling screed.

Thanks, It’s damaged and i can’t see how the loft was getting ventilation previously as it sealed the overhang against the wall. I was more concerned about if it was the nasty asbestos. So it’s all coming down one way or another and being replaced by upvc board with continuous vent grill.

Forgot to say Bungalow built in 1965

Had a search not found similar question. Removed upvc trim ahead of doing a window and found the trim was covering the original panel. It look like It might be nasty material? If I use a filtered face mask can I carry on removing the rest?

We are considering a step or a ramp. Probably going with a step