Good morning all.
Having had a look at more of the boxes it would seem that every one is wired
Black - neutral
Brown - live
Grey - unused
Bare copper - earth (sheathed)
Connected to a B16 breaker.
There are 10 sockets in total on this breaker and all using this cable as discussed last night.
That was my mistake with the 2.5. Fat fingers.
It is 1.5.
When I'm back tomorrow I'll check what terminals are used for the relevant colours and let you all know.
I'll also check the breaker, but I'm sure it is a 16a.
That sounds very likely as the previous tenant worked as a spark at a factory.
I'll remove some further faceplates and see what he's done with them.
On speaking with the spark who connected my supply for an outside building, he said as long as you know what wire he hasn't used from the 3...
I'll get photo tomorrow when I'm back at the house.
I just noted down the size and colours
The cable is 6243Y 3x1.5+1
Separate wires are
Bare copper with a green and yellow sheath
Green
Brown
Black
Read more: https://www.diynot.com/diy/threads/3-core-and-earth-sockets.574272/#ixzz70F1IRnGeknyhe
It's definitely the "plug" sockets as I took the faceplate off.
The cable is 6243Y 3x1.5+1
Separate wires are
Bare copper with a green and yellow sheath
Grey
Brown
Black
Hello,
My house has 2.5mm 3 core and earth for the sockets. I'm adding an extra couple of sockets and want to make sure I'm using the correct cables.
Can someone confirm where the earth goes and which of the 3 "cores" are used as the live and neutral when wiring a new twin socket?
Thanks
I've got 6mm swa to supply from the main consumer unit to a garage consumer unit.
The cable I'm now mentioning is for the inner lighting and power sockets.
Hi, thanks for your reply.
The outside socket is part of the "ground floor sockets" ring which is on a 32A breaker.
What I'm looking to know now is, can I tie into this and take a supply to the shed via armour cable in a 500mm trench and split it for sockets and lighting?
Hello all.
I'm thinking of running power to my shed for a few lights and a few sockets.
I currently have an outdoor socket and was wondering if I tie into this, can I then run this to the shed where I'll have a consumer unit to then split the supply to lights / sockets.
Any help would be much...