Recent content by Taro75

Perfect thanks

There is a button yes. But the receiver is dead and not showing any lights. I've confirmed there is 240v at the terminal plate and the issue is faulty receiver.

My dual receiver has packed in and I have one on order. I was wondering if it was possible to bridge any wires on the back plate in order to send the signal for hot water to come on Thanks

Superb. Thanks

Thanks very much for the reply crank39. I managed to find drawing of my exact hinge now (attached). Any ideas how to move it in/out in highlighted section? Thanks

Hi, I was wondering if anyone had any knowledge on this particular hinge. I have seen various images online but none seem to replicate this. There is a hex screw at bottom of hinge which I can operate with a 4mm Allen key. However, on top of hinge there doesn't seem to be a any screw. Only a...

Thanks for the reply I asked about replacing worktop for one with rolled edge as you mentioned but can only get exact same worktops as replacement Supplier Informed I have more than likely just been "unlucky" as this is very uncommon I've decided to take the replacement workrops splash back...

Hi, I'm looking for some advice on how to resolve blown worktop issue with supplier and manufacturer The worktops were installed start of the year and after about 6 month I noticed the edging was starting to lift beside sink. It has lifted in 4 places beside the sink , 1 of which is...

Hi, im having issues with my hive multizone and getting power to my upstairs receiver. I have 2 zones, upstairs and downstairs. I can only get power to my upstairs receiver when my downstairs heating is on. I have installed a loop wire between live and common in my receiver upstairs but still no...

Thanks for the reply John, I could probably get a cable from my loft to the new light location using your method thanks. Ideally I would like to have it on same circuit as my other light il try and fish that cable and take a feed off that. Thanks

Just checked through my loft and unfortunate it is not possible. The sofit is approx 2m below my loft floor and although it is visible it is un-accessible. Thanks.

Thanks for the quick reply. Potentially yes, i will check that out in the morning. cheers

Hi, I have just moved into a new build property which had pre installed sofit lighting. I require to add an additional light but am unsure how to feed the wires over the wooden frame of the roof. I have a pvc sofit board which is nailed to the wooden frame approx every 60cm. My...