Recent content by Tay2807

Oh I see! I just googled it. I only used the general one so this may be an option, thank you I shall see if anyone can confirm.

So the literal option then haha bloody thing i guess ill have to buy a whole new tap!

I have only tried wd40. What sprays would you recommend?

I am trying Its difficult as im worried to either wear away the nut part or damage the tap

Is this a nifty tool that I know nothing about or is it literal? Because the literal option sounds about right

Hi, I am trying to unscrew the valve inside my kitchen tap. Theyre bristan ones. I have attached a photo. It is trickling water so would like to replace the valve. I have tried boiling water, wd40. But it won't budge. Any other tips in how to remove it? Would much prefer to do this than have...

Hi i posted a photo of the taps to my original post, they are bristan but how do I find out the model? I have also attached a photo to ny reply here if the inside of my taps is this helps.

Hi, i attached a photo to my original post of the taps, they are bristan but how do I find out the model? Ive attached a photo of the inside of ny tap to my reply here too if this helps.

Hi, Yes they are bristan. I tried attaching a photo to the original post but it seems it might not be showing. I have attached a photo here if the inside of my actual tap, if this helps.

The hot tap in my kitchen is dripping. When I apply pressure to the lever, it stops. Is there a part that I can just replace or do I need to replace the whole tap? I have included a photo reference for the type of tap it is and the inside.

Hi, so i adjusted the arm and it has worked a treat, the water is now coming into the cistern just fine and it refills fine after flushing too. I have noticed that when the cistern is refilling after flushing, the valve seems to be dripping a little, I've attached a photo with an arrow pointing...

Aah yes okay! Thank you, when I was putting it back i did get stuck on this part and couldn't remember which section the arms part should be on. I will adjust it tomorrow, fingers crossed it does the trick. Ill let you know! Thanks again

Hi do you mean the fill valve? I have attached a photo of the fill valve and also the isolation valve underneath.

Hi, is this a new fill valve and also isolation valve? Do you think I'd need a whole new one? I have attached a photo of the type of isolation I have at the moment, I am unsure if im adept enough to change it over!

Hi guys thank you so much for your help. I managed to change both the float valve and flush valve washers etc, the float valve washer had a split, and the flush one was caked in limescale and has broken away. But I now have a different issue which has left ne baffled! After replacing, I...