Recent content by TAYLORIC

Cheers Kev - I'll give it a try. Kevin, also in hot water only mode. When the water reaches temp and the boiler stops, my plumber says that the pump continues to run for a few minutes to make sure any hot water in the boiler returns to the cylinder. He says that because we dont have a bypass...

Yep there are at least two T jointed air bleed pipes. So i guess i need to go at those. Questions pump running or not? and do i need specialist tool to open these vents? Also I guess i neeed to be careful of scaldig water. Thanks for the help ive been quoted 270 quid to sort the problem

Have just had the pump replaced on my CH system after the Potterton profile 50e boiler failed to stay in. The boiler was drained down for the install and since we have started back we get strong gurgling sounds in the boiler and a noise which can only be described as 'wooshing' through the pump...

Try www.cetltd.com they will swap your PCB for a reconditioned one for £35 plus VAT. I haven't personally used them but seen many positive comments on another web site and it sure beats £140 for a new one. Sorry haven't a clue about installation other than same site suggested simple to install...

I have a problem with my Potterton 80e gas boiler. Basically the ignition stopped about a week ago (have been using water heating element). Once I found and pressed the reset, the ignition started and the flame burned for abou 30 seconds before going out. This now seems to repeat, I can get it...