Recent content by TD1264

It's 10mm cable, and I think thr fusebox is rated at 40amp. We had all electrics and new fusebox in 2006 so we could switch from 7.5kw shower....we replaced with a Galaxy Aqua, but I can't remember if that was 9.5 or .10.5. Had loads of problems due to water pressure so replaced with the...

Logic....lol. I just thought.....if I have to buy a new one, then 10.8 may be a little better than 9.8? Prices range from 260 to 336 just for the 9.8! Am hoping that new brushes at £25 will fix it, but if that fail then a new one is on the cards pdq!

Hi there.... I currently have a 6 year old Mira Elite St 9.8kw pumped shower which has started to play up. Am awaiting delivery of new brushes.....hopefully these will fix the problem. If not, can I simply replace the 9.8kw with a 10.8kw? Thanks in advance for your help/advice! Tracey.

Thanks "Chrishut".... I might just do that! May save some money and a whole lot of bother!

Hi guys, thanks for all the feedback/advice so far.......but..... Chrishut.......how would I go about checking that the initial very slow flow through the shower would be sufficient to trigger the flow switch on the pump, yet not trigger a low-pressure cut out on the shower ?? Fluffster -...

Hi ... I hope you can help? I recently paid to have all my electrics upgraded so as I could upgrade to a 10.5Kw electric shower (all Part P approved etc and no problems). I then purchased the shower - a Galaxy Aqua 4000. We had numerous problems - shower either too hot or too cold, no...