Recent content by techstein

Hi SimonD i recall a small black tab i asked what it was for , he said oh nothing, i guess that was the gravity system link, nothing was doen to it heres the question , what are GRAVITY primaries, I am not sure thanks..

the changes the electronic part only, i reckon that is called the head, the danfoss electronic valve looks like this , they did not drain or bleed anything, http://www.plumbworld.co.uk/danfoss-h-series-3-port-0-12723 regarding the gravity link , i wonder if i can replace it if i remove...

this has worked for years and hapened after the service i was there and no wires were changed, when the Danfoss timer was replaced , it was taken of and old one put on no wires removed , it has lugs / connectors and was just screwed to the wall when the electronic valve was changed that...

HI All we have have had a central heating system in the house for years and no issues we could select water and heating to come ON via a timer or just water or heating only, INDEPENDENTLY. lately the burner had its annual service.After this we have had issue .. We have a Baxi system...

rocks1 ,,still the same issue washes heats water pumps it around but does not pump it out, So then i need to manually remove the water from the machine , with a hand pump or whtever, i "heard" that the main washer circulation pump works in series with this drain pump, even though...

rocks1 I see the smaller connector has 3 wires which lead to salt refil led , and the other one down to the antiflood device will try this and get back I have included pics of the back of the PCB also , looks like the diodes are micro diodes on the PCB I will try it tomorrow...

As a side note the antflood device has 3 connectors but the plug ony uses 2 as i recall it uses the top 2 connectors can anyone confirm this as hte connector is not keyed thanks Techstein.

rocks1 the board is similar to this it has 2 main connectors on it http://shop.ukwhitegoods.co.uk/popup_image.php?pID=2402&image=0 so i guess you mean the smaller connector thanks Techstein

Thanks rocks1, I Checked for green contacts I cleaned them as one was a bit green but not to bad . Now i also took out the high pressure sensor to test that also http://www.hotpoint-spares.co.uk/high-pressure-sensor-for-fdw20p-p-122251.html there are 2 pics attatched , i...

Thanks Rocks1 , will check that and post back mean while i have done some testing I figured the water level switch sets of differant devices depending on its state ,it makes connections active to diff devices , depending on the connections that are pushed down in it , by air pressure as...

I reckon these have a pressure switch and sensor as the hose from the pressure switch goes into the sump i will check this is clean and drops after sucktion is applied to ensure it is not jammed , i reckon these also have a pressure sensor , betweeen the big circulation pump, and the...

Any ideas at all, ?? is the capicator being used continuously while the machine is pumping around ?? I suspect it does charge and discharge its power rapidly to the big circulation pump As i understand it all dishwashers start with a pump out as soon as a prog is selected , to remove...

Hotpoint Aquarius FDW20 diswasher prewash and wash are flashing, a few months ago i changed the water pump it was clean but just worn out and did not pump out well,after that machine worked, fine now when the machine is turned on water comes in it gets swirled around, and is heated ...