Recent content by telelec

It was the PCB , the engineer also replaced the Fan and the APS , as he said these can cause the pcb to go, so all 3 parts plus another 12 months breakdown cover (Parts and Labour) all for £279 , an excellent service from Worcester and would recommend them to anybody with a Worcester boiler.

Just an update incase anybody picks this up on a search... the problem was the PCB board , anyway the Engineer replaced that and also the fan and the APS , as he said slight faults with these can cause the PCB to go , so all 3 pats replaced plus another 12months breakdown cover on boiler for...

well i gave up and have phoned worcester , they are doing a call & fix plus 12 months additional breakdown cover and parts on boiler for £279 payable monthly which i feel is quite good and gives that bit of protection and at least they should have the parts on the van unlike BG who always have...

anyone have any idea???

DHW has gone aswell now... ran for 10 mins and boiler has locked down and i cannot get it to restart now..... any advice PLEASE

I have carried out all tests in the service manual on test d , I cannot test the gas pressure , but assume this to be OK as hot water runs fine , resistance between pins 1&2 & 8&9 was around 75 ohms and i have continuity between 6&7. I sat and watched the boiler when i 1st turned on the CH ...

Hi , problems with my boiler , all seems ok when we just demand DHW , i have had the tap running for 20 mins and all ok. When we put CH on , this can work from anything between 10mins to 1 hour , when the boiler locks out the indicator light is flashing once per second. After turning off boiler...

sorry , just checked your post , your on VM , there telephone line has no effect on your broadband at all as it is carried down the co-ax , so you should be able to use the cable .

!st thing to do is get rid of the cable you have put in , that is alarm cable not telephone cable , this will cause interference on your broadband and drop speeds , once you have the correct cable check that you have a slave extension socket and not a master ( master have a capacitor on it), on...

There is a very good chance you will get charged for this. BT have requested Openreach to visit when there was no fault on the physical line ( Openreach Network ) , so if the engineer books the job off as this then Openreach will charge BT Retail for this , who will pass the bill onto yourself.

As already stated , you SHOULD not do this , but if you do makes sure you use external graded cable (Dropwire 10) DO NOT use internal 6 wire as this will break down in time and if you get a fault and have to report a fault then your Service provider will hit you will a bill for at least...

The bell wire you refer to is dropwire 6 , all you need to do to use this with the gel crimps is cut back the grey sleeve a little on each wire , just enough so the metal spade in the crimp makes contact with the copper. The BT80 you have used will cause you major problems if left outside as...

DO NOT DO THIS , especially if you have broadband , the extra capacitor in the 2nd nte will cause your broadband to drop out and slow your speeds down

Connext the wires in the said adaptor to terminals 2 & 5 , these are the 2 connections that carries the pstn signal.

Have you tried dialing out , if so what happens?? intermitant dial tone means you either have a message (1571) calls on divert or another service (#21#) to remove. If its none of the above , unplug everything thats plugged into your sockets and just try with a phone in the test point in the...