Recent content by tempsc

Thanks Drives. Will get the instructions from Karndean.

Thanks Dazlight. I can't find the flooring forum at all. Isn't this it?

Hi all. I am quite concerned about a problem I am having with the newly laid Karndean flooring in our kitchen. First. Some background. We wanted to change our flooring from ceramic tiles, which were laid over a mat type heating system, which was laid over a concrete sub floor with DPM. The...

Thanks crank. Yes, the door is Solidor. Only the frame is Rehau. Just need to know if the door sash/jamb where the lock keeps are should be reinforced to meet the SBD and PAS23/24? Tks

Hi. Could someone on the board assist please? I have just had a composite (Solidor) entrance door fitted - the design is with a single sidelight. The door is 950mm wide and the overall width of the entire door/sidelight frame is 1480mm. I noticed when I got home from work that the door wasn't...

Hi and thanks for the reply. Yes, what would be ideal would be to have the new roof tiles NOT in direct contact with the abutment wall, but with a gap, which would mostly conceal the abutment soaker (or other solution if there is one out there). The roof tiles will be plain concrete flat tiles...

Hi. I wonder if someone could advise me on this please? We are about to have a small extension put onto the front of our home, which will have a mono-pitch roof to just under the cils of the 1st floor bedrooms. The thing that is causing me abit of a headache at the moment is with ref to the...

Got it sorted thanks. Heater was OK, as were the different settings. Traced back to a microswitch that had burnt out. Thanks for prompt responses and advice. Much appreciated.

Hi. I have a Mira eclipse shower that has just developed a fault after a few yrs faithful service. On starting the shower the unit trips out the RCD. I've checked all the cabling back to the CU, all connections are tight and after receipt of some other advice, have checked the solenoid and have...

Yes. Just to clarify, I am trying to boost both hot and cold so guess I'll need a twin impeller pump. Whether or not it's going in the attic or 1st floor, adjacent to the HW cyl is open to what advice is given on this board in part. I guess I could also move the HW cyl to the attic too.....or not?

Tks for that. Can I fit this in the loft with my set up?

Hi. We are just having a new bathroom fitted and although we specifically chose taps that were suitable for low pressure (gravity fed) we are disappointed with the flow. Therefore, I'm wondering about whether we could install a whole house pump (which would improve things downstairs too) to...