Recent content by Testing Times

I was hoping to isolate and drain the individual radiator only. Do you think that's not possible?

I know, it's weird. Their photo that I posted, my actual setup looks like that

There's only about 100 mm clearance to the floor, so won't get it out or the new one in.

I need to remove towel rail to replace element which has burnt out. Dual fuel valves are the type shown below. I'm fine with isolating the radiator, but unsure how to disconnect it from the two valves to drain then lift off. Do I loosen the top collar (red arrow) or middle section (green...

Yes

Tiscali

Hi, I recently switched my phone line from BT to a LLU provider. Voice calls working as normal, however I have dial-up equipment for work data transfer and the connection on this frequently fails/drops for no reason since transferring my line. Is there any solution? Is this a fault on...

1.4 petrol. It's just the digital reminder: Service due now, not anything requiring fault diagnosis.

Does anyone know how to reset the digital service reminder on my 2006 New Clio? Been serviced by local independent garage who didn't have the computer equipment to do this. Thanks!

Engineer looked at it under warranty yesterday and could not explain the problem. Of course I could not get it to make the noise while he was there! Machine on again tonight and noise started again. Can anyone suggest anything further I might try?

Hi, My Beko dishwasher makes a regular (every second or so) dull thudding sound in the middle of each programme, about half an hour into the cycle, lasting about 20 minutes. First observed about a month ago, and it's only about 3 months old. This happens even if it's run empty. Can...

Just bought a new B50 Crabtree Starbreaker MCB to connect my new electric shower at the CU. The MCB rattles as if something is loose inside. Is this normal or should I return it for a replacement?

Hi I did some DIY today, removing the self-installed 20 A switch for my bathroom towel rail. On rescrewing it to the box, the live load wire seems to have become trapped between the switchplate and back box, pressing the live conductor into the metal box as it was screwed tight. So when...

Cheers. How much might it cost?

I live in a flat, obviously, I think, so not practical. Anyone know the answer to my question?