Hi, removed an old shed and clearing the old base I unearthed this pipe.
Looks like a drain valve but no idea what for or if it’s still in use. Anyone have any idea what it could be?
cheers
The Mynute 15 VHE requires 150mm above and below the 600 unit. Space under worktop is 870mm so that won't fit.
Anyone know about the new Glow Worm Energy? Or if Flexicom's are still available anywhere??
Yeah, it is a rather awkward location. Some people nearby have put them on the other wall (at the end of the sink) but it looks pretty horrible
(visible from kitchen window)
I looked at Worcester and a load of others but for most of them the manuals don't make it clear what the top clearance is when using the rear flue.
One that did specify it was The Baxi Eco Blue Advance Heat and it should fit with room to spare
Looks like my boiler has had it. Looking to get it replaced with something that can be sited in the same place. (On external wall under kitchen counter with rear flue)
Does anyone know of a Heat Only boiler that fits the bill?
Hi folks, I have a Baxi WM 40/4 PF boiler that has served me well for many years (I think it was installed in 1989)
Anyway, it has recently developed a fault where a small amount of water is collecting in one of the APS nozzles.
As highlighted in the attached image, it is the nozzle...
Progress, I moved the wire in 4 to L, and yes, when I turned back on the power, and turned up the room stat, valve moved to CH only and the boiler kicked in. Turning down the room stat switched off the boiler.
Does this prove it's the programmer? (I guess the re-wiring by-passed the prog?)...
Echo, I'll try switching that wire and let you know what happens.
Robo, programmer was replaced a few years back, the old one wasn't faulty, I replaced it for more timer options. As far as I know it's always been a pumped system. I'll check the programmer wiring tomorrow.