have wired up the bell - to the strobe - and all seems okay, strobe comes on when bell is triggered, fuse not blown so far :)
i did try the white strobe - wire in the strobe again and reset the system completely into day mode but the strobe still stayed on flashing.
I have the manual here but gives no help. Says stobe is 12v latching if that's any use ?
If I did the link on the bell strobe would it cause any electical problems with fuses etc (fire possibilities etc...)
i do not know what panel it is to be honest it was already in when we moved in the house. i have a booklet that says it is an SL8 G3 intruder alarm panel model is 8SP 402 SL8 G3 other than that i do not know.
in the panel it has :
strobe +
strobe -
T -Ve tamper
A -Ve supply (0v)
D +Ve...
my bell box only has a strobe - input but i have a + & - strobe wire, have tried just putting in the strobe - wire but the stobe is on constant, any idea how i can fix this problem. bell box is a reson8 by honeywell
cheers
i have done as you said and wired up like for like leaving out the strobe + wire, only problem i have now is the strobe is flashing constant !
is there any way to get round this problem at all ??
i have disconnected both the + & - strobe wires for now and the alarm works perfect but with no...
i have just replaced my old bell box with a new one, however my old one had 6 wires and the new one only has 5 inputs there is a + & - stobe on my old box and only a - strobe on the new one.
i was told to just tie up the blue wire (stobe +) and connect the white (strobe -) to the stobe -...