Should I have bricked in between the outrigger joists (or whatever they're called)
I added two course higher to the outside and notched the ends so I can have a smaller fascia.
Thanks all, really appreciate your help as I have the rubber man coming tomorrow!
How would you pick up the fascia boards then from the joists then?
I thought that's how Fascia's and soffits were fitted to joists left over hanging?
I found these examples on the internet...
I've just done my first flat roof and I've left noggins to pick up the Fascia's where the joists run parallel to the wall. The joists overhang at the front also for the fascia. The brickwork is two course higher on the outside so I could have a smaller fascia board by the time the warm...
I'm putting 10 x 2 joists in for a flat roof. The span is about 3m from wall plate into steel and then the same out of the other side of the steel to the fascia.
The steel section is 254 tall so I've gone for 10x 2 to give a flat roof and a flush ceiling. Can anyone advise on the...
I’m having a flat roof on an extension I am building and the area is approximately 8m x 6m - 48m2 (not taking into account the skylights) please can anyone recommend a roofing system that’s suitable for large areas such as this.
It will be visible from the upstairs windows but I...
What is the best material for the studs to be made of?
I've seen stainless steel, bzp, carbide steel etc etc and different grades.
I have some m12 x 160 anchor studs but by the time I've left them sticking out the resin they may only have 100mm bearings in the concrete? The...
Where can I buy this grout from in the East Midlands? Are there any nationwide builders merchants that sell it?
The column will eventually be supporting a second story extension.
When packing up the base plate to the column do you just put shims under the plate in between the...