Recent content by timmy74

So no ones had this problem then :roll:

only trouble ive had with these are fans, pcbs, pilot injector and aps. but i must say parts seem to be getting dearer for them. imo if its gunna cost say £300 to fix and someone would fit you a baxi solo a rated boiler for £1000 with a 2 yr gtee its a no brainer.

put us up in digs and we will come do job for £2.5k... we usually charge between £1500-£2300 depending on boiler inc flush and upstairs trvs for back boiler to combi swaps :D

Hello i was wondering if anyones had a fault on these back boilers where a clicking noise comes from the pcb? Ive been called out to a customer with an overdue boiler service and a noise from the boiler. Spent about 90 mins stripped it all down cleaned pilot, filters etc etc and put it all...

Hi Is it possible to have my cavity wall insulation checked. When weve had building work done and the cavitys have been exposed there doesnt seem to be much insulation in there. Can a insulation company check for cold spots with a heat seeking gun/tool? Who do i need to contact, many...

needs no reply just done a search on here :D

Anyone know what the hell this is about, i keep getting emails asking to quote them for work. Is it another scam :shock:

them bobbin kits are a tw@t, i aint done one of those for a long time thank god.

how with a wooden loft ladder attached to it?

I cant seal/insulate the loft hatch as its a drop down one with ladders attached. Shall i just plasterboard it, ive got some 8x2 sheets down on floor but not all of it.

ps centre of rafters approx 400mm and only 1 cable runs up inside two rafter to loft light.

hi guys the depth of rafters is 70mm ive sourced some celotex at 70mm thick. then use handy boards i think to cover and tape joints.

hi bud the stuff on the floor is minimum, i was thinking about the ceiling rafters, insulating between them then plasterboarding over. ive got a big drop down loft hatch with ladders on so its letting a draft down to the main house.

Since having a new roof fitted with breathable felt the loft seems a lot more drafty. Ive been thinking of insulating the roof then plasterboarding it, whats best insulation as not to create condensation, i would fit kingspan but its so expensive, will polystyrene boards do the job.

Boiler runs for a certain amount of time (5 - 10 mins enough for rads to get warm/hot) then cuts off, blows fuse on board. Ive had this problem on another boiler and it ended up being the gas valve as the coil was overheating and taking fuses out on the boiler. Anyone had this fault on this...