Recent content by tipdweller

Yeah, it's a bit wierd, but that's how it comes. I was going to bring the plinth forward as far as possible by padding out the plinth clips with a bit o' timber. Then the gap will only be the thickness of the front panel.

I think you're right Mark, it has to go on the bar. And yes, the cistern access is through the front. The front panel doesn't go all the way to the floor. Only to the top of the plinth. Then I'll run one continuous plinth all along this and the neighbouring units in one go. So the...

No! Really? :) The reason I haven't cut the flush pipe down yet, is that I don't know how much to cut off, cos I haven't decided yet where to hang the cistern. When I said it's too low to connect to the flush pipe, I mean the cistern outlet is lower than the pan inlet! If I hang the...

Hello, I am fitting a concealed cistern in a vanity unit, and am unsure whether I should hang the cistern on the wall, or on the inside of the unit. The back of the unit is mostly open, but has a bar across the top. If I have to hang the cistern on the wall behind, it must go under this...