Recent content by tmuk7070

Hello, I am having a problem with the program lights, on/off and start button flashing on the front display of my machine. Because of this i cannot start my machine,until it stops flashing. I have looked inside and took apart the cicuit board,checked the wiring etc,but cannot spot any obvious...

Hello. I bought patio circle last year.It is an aztec sort of design,in charcoal and terracotta colour. The problem is the colours are not as bold as they should be. I have jetwashed it to remove dust etc and has been treated with several coats of Thompsons patio seal. When it is wet it...

Thanks again Ban-All-Sheds. So, To terminate the armoured cable into the pump,i will go and buy a junction box for that,i guess,and route into the 3 way switch i`ve got,then to my pumps and two lights. Hopefully you can advise on a junction bos i need to buy. I will put the rcd double socket...

Thanks ban- all - sheds for your help. Can you tell me why i would have to replace the outside MK rcd socket i`ve bought for a non rcd one,if i were to plug the 3 way out door switch in that by just putting a conventional plug on it as a feed? I thought this may give even more protection from...

There are 3 glands coming off the 3 way switch to power the pump and two lights. Re; armoured cable..The pond pump will be 8 meters from source of power. The power supply would be taken from the circuit/socket in the conservatory,by drilling a hole through to outside,to where the weatherproof...

Hello to you all. I want to install a pond and pump and two lamp post lights in my garden. I have bought armoured cable(could do with some re assurance from someone in the know re; the type required...to see if it matches mine!) Also i have bought an Mk rcd double outdoor socket and a 3 way...

Thankyou for your time in giving that advise.I think i will get someone in who knows what they are doing! Chris

Hello, My fuse box has RCD protected sockets/water heater/cooker. I currently have a normal outside double socket. I want to install a couple of water features in my garden and use this outside double socket as power souce for them. Do i need to replace this socket with an RCD one for...

Hello, I wish to install a pond,a waterfeature and an outside light in my garden. I recently bought a 3way illuminated switch socket (5 amp),to enable me to run these individually (this will be positioned close to the pond etc) The three items will be approx 15ft away from house and i have an...

Hello. My neighbours garden is 2ft lower than mine.I have 8`9" concrete post,3 gravel boards and a 4ft panel in each section.After back filling my side of fence,i have one gravel board visible to my neighbours three.Two foot of the post is in the ground with concrete.Is this ok?