Tommohawk2's latest activity
-
TTommohawk2 replied to the thread Problems Venting System.Just done watts - they fluctuate slightly but only by about 1w: with CH and HW on CC1 5w, CC2 6w, CC3 7w PP1 3w, PP2 3w, PP3 4w CP1 2w...
-
TTommohawk2 replied to the thread Problems Venting System.So isolate pump both sides, undo joint on outlet just enough to be sure water in there? Sorry if sounding dim!
-
TTommohawk2 replied to the thread Problems Venting System.You mean break the pump inlet without draining?? Also I've got x400 I'm trying to get in there so will probably need to drain a bit...
-
TTommohawk2 replied to the thread Problems Venting System.Thanks for that. The valves were replaced but far as I know no check was done for flow. As mentioned before, the last metre leading to...
-
TSuggest first thing tomorrow is to spend just a few minutes in changing the pump from (If) CC3 to CC1 and observe the power, a few...
-
TTommohawk2 replied to the thread Problems Venting System.Thanks for that. TBH it's exactly as it was yesterday before replacing parts. Pump orientation has been checked. Coil is Def plumbed...
-
TTommohawk2 replied to the thread Problems Venting System.When I say no flow, I mean rads and hot water not getting hot. There is very slow flow, and bathroom rad got hot after over an hour but...
-
TTommohawk2 replied to the thread Problems Venting System.OK thats interesting. TBH I'm done for the day - bizarrely I've also been trying to sort my daughter's heating issues and looks like she...
-
TTommohawk2 replied to the thread Problems Venting System.UPS4 GO 25-65 130.
-
TTommohawk2 replied to the thread Problems Venting System.Not good. Removed suspect section of copper pipe but wasn't really badly blocked. Pump was pretty rammed with debris so replaced that...
-
TTommohawk2 replied to the thread Problems Venting System.Yup. He was actually really good. Tomorrow I'm going to drain again, he's then going to arrive and replace sludged section of pipes, and...
-
TYou are right to be suspicious of that auto vent. If it is piped to a low point it will not clear air sitting at the pump, so check the...
-
TTommohawk2 replied to the thread Problems Venting System.Yes I agree completely. I'm just pointing out to others there is a potential risk if their system was blocked.
-
TTommohawk2 replied to the thread Problems Venting System.Yep well I think as far as venting /airlock goes, backfill through DC has sorted it. But I guess back fill a bit risky, because if...
-
TTommohawk2 replied to the thread Problems Venting System.Shoulda worked that out for myself really!
