Recent content by Tommy87

He did not, snippets from his e-mails; "A continuity check to the solenoid valve assy could also be actioned. This would need to be actioned at the time that the fault is present." - How can the fault be present when it's not on? "In order to check the continuity to the solenoid valve this...

Eric thank you very much for the rapid response, I do appreciate it. I have tested the water pressure and it was giving me 1.5/2 bar, which I think is fine, there were times when it was running OK when I'd get low pressure fault which I believed was genuine as I'm on the top floor so I don't...

Hello, I have a triton spellbind shower that is giving me jip. It will run for a couple minutes and then give me a "low pressure" fault. I contacted Triton and was advised to check the solenoid coil, I did this and got a resistence of 3.5k/ohms which seems OK. I now have to conduct a live...

After spending most of last night & this morning looking for a spare TCO I have come up empty. I continued digging into this and have found out that although a different TCO would probably work, albeit there's a chance that I would get a slightly reduced performance, each Triton TCO has the pin...

Greetings, I apologise if electric shower queries are better suited for the appliances section. Anyway after a bit of a crash course in electric showers (a thank you to all on here for previous advice) I have identified a faulty TCO in my Triton Spellbind shower (no continuity). Triton now...