Recent content by Tript0nite

I didn’t know that was an option - so thank you for your reply on that. Will holla at them tomorrow. Thanks again!

Okay that’s great thanks for the confirmation - appreciate your prompt replies. If nothing more it’s good to know I wasn’t missing an obvious one

It’s not… In Wi-Fi setup I have the following options: Setup With Wi-Fi device? (This broadcasts a connectable Wi-Fi signal that I have connected to via 192.168.0.1 to then connect to my existing home Wi-Fi) SSID? (that option is to manually attach the panel to your Wi-Fi) Password? (Believe...

Set date and time Operate user outputs? Omit inputs? Edit users? Review logs? Wi-Fi setup? Walk test? Siren test? Dial out menu? Allow eng menu? Block udl set? Block udl? System sounds demo? Exit manager menu? that’s the master manager menu rather than the engineers menu though isn’t it I believe

I’m looking to use the HomeControl+ app on a smartphone, to do that I need the system ID which is buried in the Set Up App Data menu option. I am going in using my master manager code as I (rightly) haven’t been given the engineer code and it doesn’t exist on any paperwork left by the installer...

They do indeed. I can verify it’s connected to my Wi-Fi as well as it’s on my list of connected devices on the router interface. The green LED blinks intermittently indicating there is data exchange happening over the Wi-Fi connection

Hey Sparky thanks for the quick reply. Yes definitely connected via the white wiring loom - plenty of LEDs as soon as I power the unit up. Picture below, for reference this is with the battery connected. I removed this and power cycled the mains with the Wi-Fi card connected. Still no option!

Hi guys. We have a pyronix enforcer 32 that definitely has the digi Wi-Fi module installed and connected. It has been connected to Wi-Fi using the Wi-Fi setup option in the master manager menu. So therefore the panel has detected that it has the modem installed. So I can’t understand why the...