Recent content by upandatem

My fridge in this fridge freezer keeps freezing food, the temperature in the fridge is constantly below freezung in spite of the fridge being set at the lowest setting on the dial. The thermostat has been replaced but this did not solve the problem. The f/f is less than three years old. The...

what sort of answer is this??????

I recently fitted some chrome towel rails 3 in total of which 2 subsequently sprung a leak on the joint of the sixth or seventh rail the shop where I brought them has ceased trading. I do not know who the manufacturers are only that they are made in Turkey by the leading manufacturer of these...

I am re-posting this since I inadvertently put it in the motoring section before and obviously people could not see that it was a mistaken placement.I have a Hotpoint Ultima WD860 washing machine which keeps showing the error code F02 which apparently means either the motor is jammed or the...

I have a fault code f02 on my washer dryer. It is a hotpoint ultima wd860 I know what the code means need to know if it is fixable without the need for a service engineer I am quite a capable person and I know my own limitations. Any help would be appreciated cheers. Code means motor jammed...

CAN ANYBODY TELL ME WHAT THIS IS PLEASETHIS IS GROWING IN MY GARDEN AND EVEN THOUGH I HAVE CHOPPED IT DOWN IT STILL COMES BACK. IS THERE ANYTHING I CAN DO TO ERADICATE IT? THANKS IN ADVANCE FOR ANY HELP GIVEN.

Pictures of grass or plants in garden

Cheers Lecky758, I have had a good look at the back of the machine don't know where the tacho would be so don't know if it is detached or not, the machine tries to go through the cycle the water valve cuts in momentarily then stops when set but keeps cutting out ie goes to start then stops then...

I keep getting error code f 02 and the machine tries to start but keeps stalling is this easy to remedy . F02 means the motor is jammed or the tacho is detached.

I am lookingPDW5012PB for a spare part for my table saw. The saw is a Power Devil 10" table saw, the part I need is the geared cog that drives the blade. The cog is attached to the drive spindle and is accessed when the saw blade is removed and the cover is unscrewed. Can anybody give me any...

Could someone please explain to me what is meant by an open system in CH. I have recently fitted a chrome towel radiator in a bathroom and it has corroded on one of the cross members I have been told it must be on an open system but I am sure when I fitted it the supply was fed from the :?: CH...

Cheers for the help Neo I am also told by the man at the shop where I brought the new battery that there may be a loose earth connection and he may be right since the earth to the chassis although never been touched by me in the four years I have had the van seems to have a bit of movement in...

My electrics have gone crazy. The van starts and runs ok but the electrics seem to come and go at random. If when they decide to work I have the radio on and then switch on anything else the radio needs recoding or every thing else goes off. Sometimes I can turn off and remove the ignition key...