Recent content by UphillPhil

Just updating to confirm that Atag replaced the failed part with no quibbles whatsoever. After some confusion where they sent entirely the wrong part first time around...

It’s stuck in DHW mode regardless :) Installer didn’t think manufacturer would quibble about the part. Will report back.

He took the diverter actuator off and put it through it’s paces: It happily winds all the way in one direction, then refuses to go back the other, so it seems likely that it’s just the actuator. He was sure that makers will replace under warranty, though haven’t had confirmation of that yet...

Just in case anyone Googles the symptoms: was a failed actuator on the diverter valve.

Just in case anyone suggests it, I have trundled round and bled all the rads just in case & apart from a little air in the very top rad they were all full to the brim. Have also checked that the valves are doing their thing in response to heat request from the thermostats & they appear to be...

Have called the guy who installed it to come and take a look at the beast, but in the meantime does anyone have any ideas based on the following symptoms? ATAG A325ECX condensing boiler installed ~18 months ago. Heating system is a three loop job, each loop guarded by a valve controlled by a...

Aye, still around!

Any thoughts on the following? We're looking at ways to tile the kitchen in our mid-terrace Edwardian house. As is common with these houses, the kitchen has been extended out the back a short way & the original scullery (& presumably the original outside toilet) knocked through which means...