Recent content by Vegable

I have already contacted you and problem being rectified. Your "Samantha" has sorted it for me. Problem is/was lack of pressure in the pressure vessel. Should be 29psi and mine was around 19psi. Very prompt help from you. Thanks Mike

Thanks. Have emailed them and copied the above. Will report back if successful Mike

I have a Salamander Force 15TU pump which feeds hot and cold water to the Wash Basin and Shower in the batrhroom (only). The pump intermittently refuses to start. If you leave the tap running and go quickly to the hotwater cylinder cupboard where the pump is located and switch the electical...

I have 2 newel posts at the top and bottom of my stairs. They are fixed solid and are finished in stain and varnish. I cannot remove them with dismantelling the whole stairs. I want to install a wooden handrail, which will also be stained and varnished, between the two posts but want to use...

Thanks for your reply. I went back this morning to photograph it all and in moving wires around to get a clear picture the centre ones moved. On closer investigation they also slid upwards too. After disconnecting it and pulling, up came the thermostat, positioned right in the centre between...

An elderly neighbour has asked me to look at her water heating as she thinks she's using too much electricity. She has a Redring TR27T Immersion heater controlled by a Horstman Economy7 Quartz Control Unit. Looking in the Immersion Heater top-cap, there appears to be no thermostat. There's...