Recent content by vespagts

Hi all, just wondering if this is possible. My saw is a Homebase Powerbase Excel blade size 185mm diameter 20mm bore. Thanks

Trying to repair this, one blade oscillates but the other one doesn't. I've dismantled it but not fixed it yet. I am curious if anyone knows the purpose of these not quite full circular half holes next to the full circular full holes.....thanks

My boiler is in our garage, thinking of building an insulated cupboard for it with air flow and ventilation, what do you think? We had the problem all last winter, 3 gas people couldn't fix it, ok when warmer up, ok since last Feb

Has anyone come across a boiler failing to fire up and giving a fault code when the weather gets colder. I remember phoning the helpline of my electric garage door because it was very cold and no response from remote. He said he'd had loads of calls today with same problem, it's the electronic...

OK rhanks

My project is to install a retractable awning onto an uneven stone wall. Would it be better to fix the metal end brackets direct to the wall or fix a length of timber to the wall and then fix brackets to that, or even justify two timber panels either end and then brackets fixed to them. The...

Should be "just" not "justify"

My project is to install a retractable awning onto an uneven stone wall. Would it be better to fix the metal end brackets direct to the wall or fix a length of timber to the wall and then fix brackets to that, or even justify two timber panels either end and then brackets fixed to them. The...

No, don't have a frost thermostat. I made a mistake, I should have said F83 not F85

Don't think so, will check. Could it be in the boiler or external. Thanks

Boiler is glow worm ultimate 3. Programmer is Drayton LP522 In the middle of the night when the boiler is supposed to be fast asleep, it fires up and a few seconds later produces a flashing F85 fault. Doesn't happen every night but most I have given up trying to fault the F85, replaced both...

Thanks Eric Mark, We don't have any electronic switches. It's only just started happening and we've had no work carried out. Any other culprits?

Not seen this before. It flashes sometimes when kitchen or bathroom light is switched on, even though it is switched off. Everything else fine. Any thoughts please

Thanks, will remember that

That sounds like a good compromise, might try that thanks