Wongfeifox, Thanks for your well meaning comment about messing with
the boiler. Let me just say, that i don`t mess about with anything that
may and could be dangerous, without having some knowledge of how it
works and folowing instructions to the letter,, in this case i read and...
Thanks for your response DP. The one in the boiler i believe is faulty, the
pin in the central heatin manifold will not go in when i run the hot water.
I have read in manuals the they some times get affected by detrstus and
the filter clogs up. I tried cleaning out, and when i put it...
Hi.
Can anyone please tell if vokera do a similar - Water Governor/ Flow
Regulator - for the Vokera 20-80 RS FLOWMATIC, as the original is now
obsolete, i believe.Thanks.
Vinnyboy
45yearsagasman, i apologise, i said that i have installed a new diverter.
In fact i have installed a new 3 port diverter valve and not the diverter. Thanks.
vinnyboy
Flameport i do believe your correct, i`ll learn from it.
45yearsagasman, i didn`t touch the flow rate screw, but thanks anyway.
DP i understand what your saying, Even though i have done everything from the installation book, understanding the sequence of how things work is pobably the issue. i...
I will definetely get it serviced, when i can afford it. Can you give some idea of how much a full service costs and does it actually mean disaasembing parts or just having a quick look here and there that doesn`t even last half hour. Thanks.
vinnyboy
Thanks for the reply 45yearsagasman. I understand what your saying, but i actually replaced the 3 port diverter last month with also anew diaphram the spindle hits the dhw microswitch spot on, could it be that the diaphram has split already. When i installed all this the boiler worked fine until...
Dhw will not work if i open hot tap, but will work if i turn ch on first then open tap.
If i press the dhw microswitch then it works no problem, i notice that when i do this the heating manifold spindle goes in. Yet i open tap the manifold spindle stays out. Could this be the problem...
Can anyone please tell what the pressure should be for DHW Expansion vessel. I know the main expansion vessel is 1 Bar, but not sure if its the same for dhw one. I have the installation manual but can`t find any reference to dhw expansion vessel pressure.Thanks.
vinnyboy
The fan wasn`t running at full speed, i measured it with a multimeter and it gave 154 volts instead of 240.
I would never ask for gas advice on here or any where for that matter. Gas is definetly a pro job. If only i`d have remembered to change the pump speed to its correct position, evrything...
Hi. Can some one please help me. I have a Vokera 20-80 RS Flowmatic combi-boiler. For some reason the fan is running for no reason, i know that it runs on slow speed when the pilot light is on and fast speed when calling for heat. For the last 2 months the combi stopped working. i realised the...