Recent content by vivaro013

ive ask to clean a consertvatory roof , there no problem in cleaning roof its getting access to roof , problem is there is a slate roof i have to negioate . the roof is about ten foot of the ground and about ten foot in span with no ridge on to attach a roof ladder , has any roofing got any...

im looking for 2 windows , 1 would be a tilt and turn size 1230 mm by 1230 mm , 2nd one is a 1200mm by 1200 mm with 2 top openens , does anybody know any good web sites or suppliers

i fitted a new sealed unit in a 14 years old upvc window frame , customer is complaining seals on external beading are not water tight , ive removed beading and internal seals to check for any problems which may have accur while fitting , ive also checked sealed unit thickness aganist another...

there a lot play on the sliding mechanish, it look like one of the rollers which slides the door may be damanged

ive been ask to have a look patio slidind door , sliding unit has been installed for around 16 years , the problem is the sliding mechanism has started to stick making it very awkward to close door , does anybody have any advice on possible problem and if spares are avaiable for these types of...

do you know any web site address for different type of rubber seals

after some info ive been informed if a upvc window which is external beaded you need to remove rubber seal from inside first , this will make it easy to remove beads , then change glass , put external beads back in , come back inside and put pressure on glass and push seals back in around sealed...

i did check seal unit thickness , the gap is no more than 0.5 mm only in certain areas , can the rubber seals perishised on be worn , can there be replaced and were can i buy then out

i changed a seal unit of glass which was misted up The UPVc window is 11 years old with external beading, is there a correct way beading should be removed . Rubber seals which slide into a groove on external beading are not giving a tight fit onto glass , does anybody know how i can correct...

im looking for a replacement light fitting 240 volts controled via a dimmer swtich, which is heat resistant . The light fitting is going inside a chimmey breast were a mutli fuel fire is fitted , the fire opening is very large and the light fitting can be fitted well away from the fire , the...

2 core 1 .5 mm cable

the fire fitted is more of a small decorative fire which does not give of a lot of heat , the light fitted previous was a type you would find in kitchen a 12inch strip light shinning down on worktops . the light it self had stop working , what im trying to do is find better quality fitting which...

im looking at fitting a light in the chimmey breast there was allready a light fitted in the chimmey breast ,the idea of the light is to to light up the fire place , they is a small gas fire fitted in the hearth were some heat does go up the fire breast , can anybody recommend a light fitting...

i clean consertvatory roof using a special ladder which give you access to roof , the info im after is on upvc / polycarbanated roof are there any areas i could be removing like the fancy trim on the and cleaning on the ground any help would be appericated

does anybody know any good web sites were there show diagram and illustiations on roof