I managed to locate 2 new actuators, went to a local plumbers merchant and they had the exact model, but branded tn rather than glo.
Thanks for all the help!
tn = taconova
The flowmeters and several other bits are branded "tn", which I can't find anything about online. But they do seem to work as described above. Upward flow on the cold side.
With a bit of swapping around of actuators I've worked out that the problem seems to be with 2 of those actuators - one...
The flow meter on the right is actually showing 0L/min, the red tab is at the bottom. The one I've highlighted is showing 4L/min with the red tab nearer the top. Perhaps this answers the bi-directional question? 0 flow is at the bottom and max (4L/min) is at the top.
I have noticed that my...
Thanks for your replies and the explanations. Yes the stats are hard wired.
The zone actuators seem to be able to turn, similar to a TRV. Is this significant or are they just open or closed based on the position of the stem?
Looking at this zone in particular, the thermostat is turned off, the...
Hi there,
I was hoping to get some insight into my underfloor heating system. I am having a problem with one of the zones not coming on at all, and another zone radiating full blast and not being controlled by the thermostat. It then occurred to me that I have very little idea of how the system...
Thank you for your response! There's no DC voltage showing between the blue and orange wires. The motor turns fine by hand. I'm guessing this means it's probably the glued up circuit board that needs replacing?
Hi,
I have a Ryobi battery powered lawnmower. I recently had to repair the flex from the unit to the switch on the handle - shortly after this the machine stopped working altogether.
I have now replaced the flex (thinking that was the issue) but it still doesn't work.
As shown in the photo...
Thanks to both. Reason for battens is because electric conduits are on the surface.
I was thinking about using 4 of these over 800mm length rail. Seem sufficient?
Hi there,
I am wanting to attach some IKEA kitchen cabinets to my garage wall. The wall is a single block roughly rendered wall so before mounting cabinets I would like to put some plasterboard over it to tidy it all up a little bit. Because the electrical sockets are surface mounted I reckoned...
Hello,
Was hoping somone could suggest a fix for this problem - I am getting rainwater leaking into my ceiling through the boiler flue.
Seems to me the problem is a gap between the lead on the roof and the flue top itself (I don't even know what this is called, so I can't find any...