Recent content by warrens64

Sorry for the confusion i am getting a shower tray with legs and was told that getting a tray with upstands would give a better seal. Thankyou

Hi dextrous Thanks for the info, i wont say last question because i have not even started yet, i am having all the tiles taken down and want to know should i get a shower tray with upstands or without, also the skirting is in a proper rough state, is it ok not to have skirting and take the wall...

Thankyou once again thu think i might have to rethink my plan so as to insert the wood, thankyou

Hi Dextrous thanks for that, i have one more question i am going for a cubicle but only have stup walls would the sprial plaster board fixings been a good enough fix to hold the weight, and thanks once again

Hi all need some help please, i live in a 1st floor flat with a concrete floor, and am replacing the bath for a shower as i cant use a low shower tray and cement it in is their a good make of shower tray which comes complete with shower legs and if so how is this fixed to the floor to as to...

Ok as per my other post the shower is a little out of my price range, i have about 1.5 meters of 15mm pipe coming from the 28mm cwds and 2 meters of 15mm from the hot water supply would it help if i replaced the 15 mm with 22mm tube Thanks for any help you might offer

Ok sorted it, having read other posts from other thermostatic showers i now know i need a pump as i have not got enough head there is only 2 meters from under side of cws tank to shower body, and 1.6 meters to shower head. Ok time to find more money i have not got

Hi all i have been to the previous posts to make sure my problem has not been covered i cant see that it has been, ok here is the setup. I have just installed the ts1850 shower the tank is about 1.8 meter above the shower head, before i connected to the shower i run both hot and cold over the...

It is possible you have a air lock near the bathroom radiator, the best way to fix this would to be taking the bathroom rad of and letting the valves run into a hose or bucket do this at full presasure this should get rid of the air , as the vent in the rad would be to small to shift any air...