Recent content by Wayne_694

ok got you, also when flushing the toilet would a 90 deg bend in the drain be alright wouldn't a 92.5 deg bend be better?

Why would I need the MAC-EXTB wouldn't the MAC-8 just go straight into the cast iron drain? also when flushing the toilet would a 90 deg bend in the drain be alright wouldn't a 92.5 deg bend be better? thanks for your help.

just waiting a good seal... them pan connectors don't look up to much last thing I wasn't is it to leak

would you know of a solvent weld pan connector?

so the MAC-8 pushes inside the MAC-EXTB ?

Hi guys, can you help what is the correct fitting to use, I'm after a bend 92.5 or 90 deg to suit 110mm waste pipe one end and cast iron drain the other, the cast iron side is 90mm can't find where to buy it. I have attached photos of what was in place. Thanks

Thank for all your help much appreciated, I am about to replace all the pipework then I will fix the joist, moving the trap is not an option in my head as this is a lot of work. is there any other options? I will post more photos tomorrow once I have done my Christmas shopping. Would this part...

Thanks for there advice, the survey was done through the mortgage company part of the deal for the joist how would you fix that?

I have just moved int to the house, would building control be involved in a new bathroom been fitted?

I have just moved into the house that has all just been done up, and yes you are correct how would you advise a fix? is this a big job and I should get someone in?

thanks for your advice, so just a few points the main worry is the pipe has no vent and is is straight to the drain is this ok? and you're saying if I plumb the shower and basin into the top of the soil pipe it will be ok as long as the fall is 1:60 or 1:40? can you suggest what fitting to use...

The soil pipe goes for about 2 mts along the main wall and then must go out to the chamber, the manhole is just the other side of that main wall, I think the soil pipe dose not have much of a run off on it, I can lift it up a little bit but not much, granted it is plumbed in incorrect, how...

it looks like the main soil pipe sits straight and will need more of a fall it ?

yes this is possible

yes this is quite possible :(