Wayners's latest activity
-
How do you blank off a washing machine sinks waste spigot? Under kitchen sink I need to remove washing machine pipe. Ill just pull pipe... -
Wayners replied to the thread Looking for the Lintel.Probably wasn't one. When I've made bigger openings I put a £20 concrete lintel in you can pick up as some DIY stores. Just solid thick...
-
Wayners replied to the thread Office within garage - Insulation in regards to home insurance.You probably need building control and convert to building regs although probably don't need planning. From what I've seen people do...
-
Wayners replied to the thread Replacement hinge.Screwfix sell. Also buy online. Just a case of matching up best you can and fitting. Measure to get same. If it's not something you...
-
Wayners replied to the thread Where to buy smooth finishing render mix.Tyrolean is old I guess. I was applying that in late 80s as a teenager. Getting mix consistency correct was the problem as you needed to...
-
Wayners replied to the thread Where to buy smooth finishing render mix.Sandtex Trade’s High Build Textured Decorative Coating. It's like really thick paint and you roll on to give a textured pop pattern. I...
-
Wayners replied to the thread Concealed cistern replacement without breaking tiles?.Look up flush plate removal. Be easier and another access point. Look for brand markings as will help to be specific
-
Wayners replied to the thread Camper van conversion, roof insulation.CT1 or foam I guess, or combination of both as you need the grab. Don't they have a timber frame on roof to fix panelling? The overboard...
-
Wayners replied to the thread Damp around bay window.Brickworks needs pointing Then where sill enters wall don't look good. Water can get in and run under the flat top off bricks under...
-
-
Wayners replied to the thread Base - slightly out of square.I just had to go look at what I used on shed base. It's that green jute twine as its dont have any flex. Well maybe a couple of mm but...
-
Wayners replied to the thread Base - slightly out of square.Get two lengths of string the same length. Put them both on the same corner to corner. Mark both. Move one so you have one on each...
-
Wayners replied to the thread What tool do I need for this nut?.As I said Screwfix also sell. Just for others if they have a need.
-
Wayners replied to the thread Primer recommendation.You need a shellac. Wire wool and meths will clean it I think.. Plenty of. If it's thick wax use paint striper and wire wool as it is...
