Recent content by Willandthebarn

  1. W

    Adding Cables and Sockets in Kitchen Stud Wall Insulated with PIR

    Thanks. In regard to cable rating, what reference method / installation method did you design to? Within insulated wall or free air?
  2. W

    Adding Cables and Sockets in Kitchen Stud Wall Insulated with PIR

    Unfortunately the face of our studs are positioned so that the PB sheet meets flush with decorative stone & brick window reveals. Adding a batten layer would bring us out too far. I did post our scenario but no responses yet
  3. W

    Adding Cables and Sockets in Kitchen Stud Wall Insulated with PIR

    Hi @JKBDIY . What did you do in the end? I’m about to do similar and scouring the forums for best approach. TY
  4. W

    Reference method: insulate wall void

    What would be the most appropriate reference method for a cable installed in this manner. The image shows a top down cross section. There is a 20mm service void at the back of a 100mm stud wall (80mm PIR). Is there a better way to install the cable here?
  5. W

    Draining all water from UFH pipes?

    Good shout. Any ideas on how to dose and circulate between the zones. Again, no power to the site yet.
  6. W

    Draining all water from UFH pipes?

    Winter is approaching and our barn conversion is without a boiler installed, and no mains electricity on the horizon, therefore, no way of heating the place. The ground floor screed has been poured, with the UFH pipes (pert-al-pex) filled and under pressure. My concern is the internal room...
  7. W

    How to install services through existing concrete floor and DPM

    Thanks for this, how would you suggest the physical or liquid DPM would be installed if core drilling?
See more
Back
Top