Last week my alarm panel reported "Downstairs Hall Wireless - low battery".
The Downstair hall sensor is on our front door and is the main entry/exit.
I have replaced the battery (twice) but the error will not clear.
According to information I have seen it should just be a matter of accepting...
I have my Pyronix Enforcer set up with A (away / all sensors enabled) and B ( home / door & window contacts only) zones. Is it possible to display the armed status of the panel, either on the LCD display or by illuminating the A or B buttons depending on which zone is set.
We set zone B...
Thanks Sparkymarka. Setting Front door contact as 10-FX give me
Front door as exit/entry when zone A set
Front door as alarm when zone B set
Perfect! There was one other change I made that may have had an impact for the Front Door contact I changed the Input Area from All to Any. I haven't had...
Is it possible on the Enforcer Panel to configure the same sensor more than once?
eg Front door contact - configure as Type - 7 Final exit in Zone A and as Type - 6 Intruder in Zone B?
The manual for the MC1/Shock/WE shows the shock calibration jumper in the middle of the sensor but the physical sensor has not jumpers at this location. The physical sensor has 3 pairs of jumpers in total but none in the middle of the sensor as per the manual. Two pairs of jumpers are at no.1 in...
I have checked system options 2 key holdup. It was set to both. Changed it to bells but still no panic function. Checked both fob and keys 1&7 on panel.
The Pyronix Enforcer Kit comes with the DIGI-WIFI communicator.
I have connected the Enforcer to my WIFI and verified the signal (14)
Manager menu does not have "Set Up App Data" option as per manual 14.8. The manual has a note that this option is only visible with a Homecontrol+ compatible...
A clean start was the first thing done on the panel.
I can set B with fob or pin. Either way B lights correctly while arming.
I removed the fob and re-entered leaving all as default. I+II still do not generate panic. I notice that 1+7 on the panel should generate panel if enabled. Currently...
Home - all door/window contacts set
Away - all set including PIR's
I have all inputs as zone A and only the mag contacts as B.
I will check the log in the morning although no messages/warnings on panel
Thanks for the comment. I wanted to rule out something silly prior to contacting support.
Everything else appears ok - tags, keyfobs etc all set up altough struggling to get the keyfob set up for panic on bottons I&II together.
I have tried just learning and naming keyfob with rest as default...
I have just completed programming my Pyronix Enforcer v10
5 x magnet contact/shock sensors set on downstairs windows & patio doors - A & B
2 x PIR's - upstairs and downstairs hall A only
1 x door contact on front door A & B
All programmed and working except for exit.
If...