Recent content by withnail69

Thanks everyone for all your help. I have turned on the warm start function and its definitely made a difference. Shower is about ten meters from boiler though so still takes a good three minutes to get hot but it did used to take about 6 so a massive improvement thanks everyone. I'll get a...

And sorry yes its an ecoTEC pro 28

Sorry this is my fault... It isn't actually high and close to the red bar its low and close to the red outline bar at the bottom of the gauge

THanks so much for that info Jack... Pretty sure needle is permanently on the cusp of red but will take a closer look tonight and report back. It did seem a tiny bit better once I opened up the valve and added some more water into the system. Thanks again Jack really appreciate your time :)

Thanks so much to anyone that can help me. I have a couple of questions. Any help/advice at all would be very grateful for. 1) I've heard that with this boiler its possible to have instant (or practically) instant hot water. Does anyone know what I need to change to achieve this? (boiler was...

for the helpful reply... smell seems to be where the main motor part is (sorry for the crap terminology) where the outlet is basically... ie:- not from the shower but happens when water is running in shower

its 100% impossible to install a normal toilet that wasn't what I was asking. I know they are a pain and as mentioned in the OP the sink and shower is connected

Hi everyone. I bought a place around a year ago and it already had a saniflo pro installed. Its actually been ok (as ok as saniflos can be) (touch wood). What happens occasionally is that when the shower is on (shower, sink and toilet all connected) a nasty smell can omit from the saniflo... I...

Thanks to all esp riveralt, simon and RF lighting... My sparky friend came round last night and checked it out. He did the whole thing live which was un-nerving for me but when you know what you are doing its like watching someone very decent with chopsticks...Well chopsticks, electrical...

as I understand it with the change you recommend. There will be nothing in L2... the change (from the config showed in my terrible picture above) would be moving the brown thats in L2 into the common (two browns in common and grey and brown in L1) Thanks for your time and help. I'll...

just for clarification here is the config with the light working and fan not...

I think if I was going to kill myself I would have already. I understand your point but you're making it regularly, repetitively and not just in this thread. Other posters have commented on your comments in this thread so its not just my POV. I've also seen your comments on other threads to...