Recent content by WJAM29

Hi, Does anyone have a MEM M6 Type 1 20 AMP fuse going spare? Many Thanks Will.

Hi Gaz, Sorted it. The alarm only had two active wires. So I connected them to pins 2 and 5 on the back of the ADSL face plate. To overcome the wire width I stripped of the end and bent back the bare wires on itself and then punched it in with a punch tool. Thanks very much for your help, I...

Hi, Just an update, looking at the rj11 on the other end with the clip sticking up I have from left to right yellow green red black. Does that help? Many thanks Will.

Hi, Got exactly that wire combination but unfortunately it doesn't work. The alarm doesn't make a call :-( Any ideas? Cheers Will

Hi Gaz, Thanks for the info, just about to try it now. Cheers Will.

Hi, I have just moved my Yale alarm to a new location and was wondering if the telephone connection can be hard wired to the connectors in the back of my ADSL face plate? I have attached a few pics of what I am on about. If it's possible does anyone know the pin outs for the connection? Many...

Hi, I have exactly the same issue in my chalet bungalow and was wondering if you have managed to sort yours. I was wondering if I could lift roof tiles and king span from the outside instead of ripping the original plasterboard? Any ideas? Many Thanks Will.

Thanks very much for the advice. I wonder what I'll be doing this weekend? Regards Will.

How do you set it? It almost sounds like it should be connected to the electrics? Is it not the case that when the hot water and heating turn off the pump overrun will increase the pressure in the system causing the valve to open? The more you wind the valve in the higher the pressure will build...

Hi, Thanks for the reply. Are they easy enough to change? The airing cupboard is in a bedroom so would like to stop the noise. Many Thanks Will.

Hi, I have this installed in my airing cupboard and it's making a rattling noise. Any ideas what it is? Is it some kind of pressure release valve? And I take it shouldn't rattle? Many Thanks Will

Hi, How would I get round the fact the lintel feeds into a cavity each side? This acts like a tunnel feeding air through the lintel straight into the cavity and the floor space above. Many Thanks Will.

Hi, Thanks for the replies, is it work contacting building control as this was created in 1988 and I have all documentation for it. On the other hand could I attack the issue from either removing the cladding on the roof of the porch or lift the roof tiles above? I'm a little concerned how...

Hi, I'm just about to fill this lintel with expanding foam and cap it with UPVC cladding before winter. Does anyone have any other ideas or advice on this? Many Thanks Will

Hi, Any advice? Cheers, Will.