just that I had a few lengths of 15 mm left over.
By the way if I wanted to put some isolation valves on to isolate the pipes can I use normal mains hot and cold water ones
Hi have a rad which I thought had 10mm copper tubing but turns out its 8mm. Can I change this by putting on a 8mm to 15mm reducers as I want to move the rad about 5 mtrs from its current location.
Will this cause any probs in the performance of the rad. :?:
By the way if I wanted to put...
Hi I need to move a rad and to save draining down the system was thinking of using these pipe freezing sprays.
Do they work and are there any probs they can create.
Also I have seen these bungs on the market but am confused as to how to use them...
Help
Hi I wonder if somebody could advice me.
I have just removed my bathroom tiles and on 1 wall the plaster came off very easily with the tiles leaving a sand cement render. Can I tile onto this and if so what adhesive or preperation do I need to do.
Can somebody please tell me if the speedfit push on connecters are suitable for using on copper tubing 15mm and 22mm if a shower booster pump is fitted.
Are they ok to handle the the extra pressure when the pump is pushing through all that water...
Thanks
I need to move 2 rads in 2 seperate bathrooms. Both are connected to that horrible 10mm tubing.
If I put on 15 to 10mm reducers and then ran 15mm copper pipe to where I want to put the new rads will this create any problems in flow or performance or anything else.
Also once the new pipes...
I am changing the bathroom and as there are no isolation valves fitted to any of the pipework in the bathroom I need to turn the hot and cold supplies off.
The cylinder in the airing cupboard has some gate valves which I turned clockwise but none of these turned the supplies off....
Which...
Thanks for your reply. My main concern was about putting a 90 degree bend in the new pipework and getting a blockage in that corner so is there a bend with a rodding access that you would recommend.
I assume this also means that when I box this pipe in and tile it this will all have to be...
Hi I am looking to move my existing toilet into a different position in the bathroom. I need to move it onto a differant wall about 5 to 6 feet away. I want to keep the extended pipework above the floor then box it in.
Can I extend the waste pipe with a bend in it and connect it to the...