Recent content by Wullie1967

Sorted soarkymarka my zone 3 pir had a wire that came loose put that in and alarm is working great I can’t thank you enough and appreciate your time patience and effort well done to you

Ok mate done everything and looks good now I can set it now but when I do zone 3 light comes on and it just beeps for ages

Sorry for asking why does that need the loop wire if I’m taking away

Ok got you now brilliant and when I move green and white wire from zone 4 which you have circled in red I need to put a we loop wire back in those 2 terminals is that correct and thanks for your help you have been great

Thanks mate I understand most of it apart from the terminal part when I disconnect from that I will have 2 single wires connect them back together and put a spare un used terminal in that strip, so I think I take the blue and yellow out terminal block and the 2 wires they where in beside connect...

Don’t understand that one mate sorry and is it just the blue and yellow coming out zone 4 cable

Got it now

Can’t upload photo saying too big

So I followed the green and white wire from zone 4 into the cable and there is red and black wires and yellow and blue so I don’t know which one is a tamer wires I have put bit of white tape round the red and black of zone 4 cables as you will see in pictures

I will send a picture in couple hours and see if youse can help, I think if I just get these wires that are linked to sensor that was removed I will sort it

According to my wall we moved in dinning room it says zone 4 on my keypad so I went into my pannel and moved the 2 wires going into zone 4 they where green and white wires but nothing changed

Accenta g3 alarm won’t set but battery is new, so when I disconnect it all put it back together the alarm goes off then I put my code in and alarm stops but after that I try set it again the keyboard beeps every number you press which is normal but it won’t set and the TA light is flashing so...